Showing 11–20 of 44 results
This saddle features a partial basket design. It has semi-round skirts and a 15/16 plate rigging. The 4″ cantle has a small Cheyenne roll and the short post horn measures 3 1/2″ x 2 3/4″.
This saddle is roughout with semi-square skirts. The 4″ cantle has a straight cantle binding and a 15/16 plate rigging. The horn is 3 1/2″ high with a 2 3/4″ cap. It has stainless rings on the rear strings.
This saddle was designed by well known cowboy and horseman Bill Smith of Spur Texas. It is primarily used in Ranch Horse and Versatility competitions but is also good for everyday livestock work.
The seat is made flat enough for arena work but also has enough rise to be comfortable for long rides and hard stops. The swells set a bit higher than some of ours, and have leg undercuts for a narrow, comfortable seat.
It features a plate rigging and a rear rigging built into the rear jockey . The horn has a smaller 2″ cap. The saddle shown is made roughout. The skirts are lined with long lasting, 100% wool felt. This has a dense, shock absorbing effect without the break down over time of woolskin.
The Bill Smith Ranch Competition Saddle is made with handmade hardware and superior quick change stirrup buckles.
This saddle features semi-round skirts and a 4″ cantle with straight binding. It is full roughout with the skirts and rear housing being Carlos Border stamped. It has a Flat Plate Rigging and a 3″ high horn with a 3″ Duck Bill cap. As with all of our saddles, this one comes complete with latigos, cinches and covered stirrups of your choice.
This saddle is roughout with round skirts and a double D-ring rigging. The 4″ cantle has a straight binding. The horn measures 3″ high with a 3 1/4″ cap.
This saddle is fully basket stamped with semi-round skirts. The 4″ cantle has a small Cheyenne roll and a 15/16 plate rigging.
This saddle is made roughout with square skirts. It has a 15″ seat and a 4″ cantle with a straight binding. The horn is 3 1/2″ high with a 2 1/2″ cap. The rigging is a 15/16 plate. This saddle features Cowperson Tack conchos.
This saddle features square skirts and a 4″ cantle with a small Cheyenne roll. It is full Floral Carved and has 5/16 Flat Plate Rigging. The horn is 3 1/2″ high with a 2 1/2″ cap finished at 3 1/4″.
As with all of our saddles, this one comes complete with latigos, cinches and covered stirrups of your choice.
This saddle has semi-square skirts, a plate rigging and a skid seat. It has partial basket stamping, a 4″ cantle with a small Cheyenne roll along with CPT conchos. The duckbill horn measures 3 1/4″ with a 2 1/2″ cap.
This Mansfield saddle is made on a 14 1/2″ tree. It is completely roughout with semi-round skirts. The swells are 12″ wide and it has a 3 1/2″ cantle. It has a 15/16 plate rigging and was made with stainless steel conchos.